How to Hack the WPS PIN with Reaver
Posted: Thu May 23, 2019 1:13 pm
How to Hack the WPS PIN with Reaver by Master OTW's Hacker Training Camp
https://www.hackers-arise.com/single-po ... ith-Reaver
this is used to guess the 8 digit pin code that can setup the router.
tool specially designed to brute-force the WPS PIN named Reaver , built into Kali and other Linux security distributions,
Step #1:Reconnaissance for WPS Enabled AP's
locate AP's that have WPS enabled and not locked. Use recon tool called wash with Reaver.
Put your wireless interface into monitor (promiscuous) mode with airmon-ng.
if you wireless network device is wlan0, airmon-ng will likely change its name to something like wlan0mon (make certain to use the actual monitor device name available near the bottom of airmon-ng output).
Step #2 Cracking the PIN with Reaver
https://www.hackers-arise.com/single-po ... ith-Reaver
this is used to guess the 8 digit pin code that can setup the router.
tool specially designed to brute-force the WPS PIN named Reaver , built into Kali and other Linux security distributions,
Step #1:Reconnaissance for WPS Enabled AP's
locate AP's that have WPS enabled and not locked. Use recon tool called wash with Reaver.
Put your wireless interface into monitor (promiscuous) mode with airmon-ng.
Code: Select all
airmon-ng start wlan0Code: Select all
wash -i <interface>Step #2 Cracking the PIN with Reaver
Code: Select all
reaver -i wlan0mon -b <BSSID> -S -v- wlan0mon is the name of our wireless device in monitor mode
BSSID is the MAC address of the AP we are attacking